A Cleanaire Heat Recovery Ventilator will CONTINUOUSLY:
- Remove condensation and reduce humidity
- Exhaust stale, humid, polluted air
- Replace stale air with filtered dry, warm outdoor air
- Transfer waste exhaust heat to incoming fresh air
- Help to create a more even temperature throughout your home
- Save up to 15 times more energy than it costs to run
- Reduce greenhouse gas emissions by recycling energy
Healthy Homes Need Efficient, Controlled, Ventilation
The Building Code specifies ventilation requirements.
Effective vapour barriers, window and door seals make a modem home virtually airtight, retaining indoor heat and meeting energy efficiency standards.
Unless ventilated, indoor humidity and stale air rapidly increase.
Excessive humidity causes condensation, mould, and mildew, which slowly but surely destroys surface finishes and furnishings.
Stale air contains pollutants and irritants which activate allergies, cause tiredness, headaches, dizziness, and nausea. A warm, humid, stale atmosphere encourages the spread of winter viruses between occupants.
Stale air contains carbon-dioxide (CO2) which results from the simple act of people breathing. Excessive CO2 is poisonous to humans, causing drowsiness, tired eyes, and irritability.
“Just the thought of breathing stale air, expelled by other occupants, is a good reason to ensure adequate ventilation of your home”
The introduction of the Building Regulations 1992, ensured a market for home ventilation products because the Building Code demand “tight homes” but its answer to home ventilation remained “opening windows.”
Open windows mean insecurity and energy losses.
Therefore homes do not get ventilated, indoor moisture accumulates, unhealthy IAQ results, and structural damage occurs.
New Zealand Standard (NZS4303) “Ventilation for Acceptable Indoor Air Quality” requires a minimum ventilation rate of .35ACH (Air Changes per Hour) – i.e. a complete air change every 3 hours. This can be achieved by opening windows or mechanical ventilation. Opening windows are often not practical and can be a security concern.
We recommend researching further before building your new home – the following references to “Build” – published by BRANZ (Building Research Association of NZ), include dozens of articles & horror stories on IAQ (indoor air quality) and moisture in homes.
Some major areas of home construction today only have to meet durability time (lifetime) of 5, 10 or 15 years! The days of the 100 year home are numbered. Structural durability is not an area of our expertise, but what we see, time and time again is failed durability due to totally inadequate ventilation design.
There has been increasing awareness of water and moisture problems in homes – leaking homes, weatherproofing, excess indoor moisture due to poor ventilation, sick homes, dust mites, humidity and occupant health etc.